ESD monitor for Primus One® system profiles
Monitoring of work in conformity with standards
The ESD monitor is used for continuous ESD monitoring at the workplace. The correct earthing of the tabletop and of the employee is recorded without interruption. In the event of a fault, a signal is given and the table is optionally switched off.
- The daily wristband check and the correct connection of the table earthing are carried out independently by the ESD monitor
- Monitoring by two satellites for personal earthing (left and right)
- Both satellites are equipped with a parking position for the wristbands
- 8 LEDs indicate the states of the components to be monitored
- In the event of faulty earthing of a component monitored on the monitor, this is signalled via an acoustic signal
- Optionally, the table can be switched off automatically if the error is not corrected within a certain time
- Individual colouring is possible for ESD monitor for Primus One® system profiles
B = 80 mm, H = 480 mm
1 / N / PE
- Front panel traffic red (Order no. K5-1E00DE.480.3020)
- Front panel signal blue (Order no. K5-1E00DE.480.5005)
- Front panel black grey (Order no. K5-1E00DE.480.7021)
3 / N / PE
- Front panel traffic red (Order no. K5-1F00DE.480.3020)
- Front panel signal blue (Order no. K5-1F00DE.480.5005)
- Front panel black grey (Order no. K5-1F00DE.480.7021)
Alternative:
ESD monitor for 3 HU cassettes
- ESD earthing cable (Order no. 01-42 X01)
- Wristband (Order no. 01-41 X01)
- Warning lamp (Order no. 94-2C Z636)
Ordering catalogue
pdf / 18 MB